Airsoftpedia Upgrades and tuning
How Do I Set Up the ETU in My Delta Armory?
How do I set up the ETU on my Delta Armory replica?
Put the gun on semi-auto and hold the trigger down until you hear a beep.
The gun starts beeping and lets you choose between the individual branches of the programming tree (one beep is the first branch, two beeps the second branch, three beeps the third branch).
To programme the settings in the first branch, press and hold the trigger after one beep from the gun, and you should hear the signal again.
In the first branch you can choose between two options: one beep is semi-auto in semi mode, two beeps is binary in semi mode (in this mode the gun fires both when the trigger is pulled and when it is released). If you decide to set binary in semi, for example, hold the trigger down after two beeps from the gun until you hear the signal (2 beeps from the gun).
This is how the gun confirms your choice and saves the setting.
Programming the second branch works the same way, only here you choose between full-auto and 3-round burst in full-auto mode (the gun fires only 3 shots in full-auto mode, after which you have to pull the trigger again to fire another 3 shots).
In the third branch the gun lets you choose between 5 spring preload levels (1 beep is the weakest preload, 5 beeps the strongest). Spring preload gives a faster response from the gun when you pull the trigger.
However, some models may fire 2 shots in semi mode with the strongest preload setting. This is caused by too much preload – mechanically the gun cannot catch the piston in this position – and you solve the problem by reducing the preload setting to level 4.
WARNING! When the spring is preloaded, it must be released after the game so it is not weakened by being compressed for a long period.
How do you do that? Switch the gun to full-auto and fire a few shots. This releases the spring and the gun is ready for storage.
Other signals from the ETU:
3 beeps – Battery connected
4 beeps – Critically low battery voltage. The ETU keeps beeping.
1 short beep – ETU overheated
1 long beep – The cycle cannot be completed (motor blocked, wheel rotation not registered, very low battery voltage etc.)








































































