BalystiK Compressor Maintenance Kit, for 300 bar HPA Compressor

The BalystiK Compressor Maintenance Kit is a set of spare parts for the BalystiK 300 bar (4500 PSI) HPA compressor – the compact, oil-free compressor for filling HPA tanks for airsoft. The kit contains the wear parts that need replacing at regular servicing: O-rings, filters and other small parts for the compressor's cylinders and valves.

A high-pressure compressor works hard, and it is mainly the O-rings in pistons and cylinders and the filters that wear. The manufacturer's manual recommends a service with O-ring replacement and cleaning every 50 fills of a 500 cc tank or after 50 operating hours in total. With the kit ready on the shelf, the service can be done straight away instead of the compressor standing idle while you wait for parts.

What you get with the kit

Why it is worth keeping a kit in stock:

• Made for the BalystiK compressor: BalystiK states compatibility with the 300 bar / 4500 PSI HPA compressor (BA-HPA-COMP) – so the parts fit without you having to source O-rings in the right sizes yourself.
• O-rings for pressure sealing: Worn O-rings on pistons and cylinders give lower output and longer fill times. New O-rings restore the seal.
• Filters for clean air: The filter parts keep dust and dirt out of the compressor and the HPA tank – important for both the compressor and the regulator in your replica.
• Same type of kit as supplied new: The compressor comes with a spare parts kit (filters, O-rings etc.). This kit is for when the first one has been used.
• Less downtime: With the parts ready, the service can be carried out following the manual, so the compressor is quickly ready to fill again.

Maintenance and safety

• Switch off the compressor and disconnect the power before opening the housing – and make sure the system is depressurised.
• Follow the manual's order when disassembling, and check O-rings, spring and check valve for damage and dirt.
• Lubricate the O-ring on the high-pressure piston with a little silicone oil on reassembly, as the manual recommends.
• Never fill tanks beyond their approved working pressure, and never set the compressor's automatic stop above 300 bar.